ID-CCU,InteliDrive DCU Industrial,ID-DCU,ComAp
概述:
;电话:0754 - 0754;;电子邮件:13556343315 @139.com;咨询QQ:49960677
Deep Sea Electronics PLC Can connect to ‘Eco friendly’ engine ma
本信息已过期,发布者可在"已发商机"里点击"重发"。
;电话:0754 - 0754;;电子邮件:13556343315 @139.com;咨询QQ:49960677
Deep Sea Electronics PLC Can connect to ‘Eco friendly’ engine management systems of electronic engines providing engine protection and instrumentation without requiring additional senders. Comprehensive remote communication via optional RS232 port. Provides RS232 Modem link to PC via either PSTN line or GSM network (using a suitable modem). The module can also signal Engineers via their cell phones using the GSM SMS messaging system to advise of system alarms.


- sourcepower发布的信息
- InteliDrive Nano WP,ID-NANO-WP,InteliDrive Lite,COMAP
- Mains failure autostart.No-break transfers.Test mode with scheduler.Maintenance timer InteliCompac NT MINT For gen-sets operating in groups.Island or parallel operation.Digital load ...
- ID-FLX-LITE,InteliDrive Lite EM,INTELIDRIVE EM,ComAp
- Bernini Be20 This module monitors a diesel engine and includes a 30A Key-switch for manual start.Automatic fault protections include:Low oil pressure,High Temperature,Emergency and Belt brea...
- InteliDrive Lite FPC,ID-FLX FPC,InteliDrive CCU,ComAp
- DIN 96x96x50,temperature range -30/+70°C 7 outputs,5 switch inputs,1 analog input Pre-Glow setting,7Vdc up to 33Vdc supply 8 LEDs,2 push-buttons,30A Key-Switch Manualand Automatic opera...
- InteliDrive DCU Marine,ID-DCU MARINE,InteliDrive Mobile
- Optional RS485 ‘Modbus’ output. Using industry standard communication protocol allows full system integration into new and existing building management and control schemes. Engine diagnost...
- ID-MOBILE,InteliDrive Mobile Logger,ID-MOBILE LOGGER
- 可用于对并入电网的发电机进行控制,只须简单的手动调节即可使所有发电机组输出恒定的电力至电网。 LSM201可以监控电网,发出信号使发电机调整其输入电网的电力,使电网电力保持恒定。LSM201负荷分配模块与...
- InteliBifuel 2,IBF-2,InteliBifuel 20,IBF-20,EP300,EP250
- 在发电机带有负荷时,检查交流器(CT)的相位,瞬时的、按顺序的短接每一个CT,每次仅一个,电压读数会减少1/3。如果没有,则很有可能表示CT不合适或相位不对。相位纠正必须在发电机停止时才进行。电线连接...