PE蛇皮袋丝印油墨 

【基本性能】
承印物：
冷确2小时后进行性能【使用说明】

1、网 板：250—350目聚脂丝网印版
2、胶 刮：建议使用70-85度聚氨酯胶刮
3、参考用量：250 目网板印刷约为30㎡/㎏
4、选用溶剂：719快干水，718中干水，783慢干水，因印刷环境温度、通用量及印刷图案大小不同进行适当选择
5、网板清洗：选用有机溶剂清洗（如：洗网水）

 

【固化剂】

 

【干燥条件】

 

 

【产品包装】

  1公斤装、5公斤装、20公斤

【保 质 期】

  5℃—25℃条件下可存放两年，避免强光照射、防接触强酸、强碱。

【注意事项】
1、市场上材料具有多样性，请先进行性能测试再批量印刷。
2、酒精测试、附着力测试、耐磨擦测试等其他测试需等油墨完全干燥后方可进行。
3、油墨，稀释剂使用及储存时严禁烟火。使用时注意施工场所的通风状况良好。
4、尽量避免皮肤直接接触，对本品过敏者，使用前应涂覆一层皮肤扶肤膏或戴不渗透手套。
5、本品不慎溅入口、鼻、眼、耳内，应用大量水清洗或直接求助医生。

[basic performance]
Printed matter:
Performance after 2 hours [instructions]
1, net board: 250 - 350 mesh polyester screen plate
2. Scraping: it is recommended to use 70-85 degrees of polyurethane scraping
3, dosage: 250 mesh screen printing is about 30 kg / square meters
4: 719, selection of solvent drying water, dry water, 783 dry slowly in 718, due to the environmental temperature, and the amount of general printing printing patterns of different sizes were chosen
5, net plate cleaning: use organic solvent cleaning (such as: washing water)

[curing agent]


[drying condition]


[product packaging]
1 kilograms, 5 kilograms, 20 kilos
[shelf life]
It can be stored for two years at 5 - 25 - C to avoid strong light, contact strong acid and strong alkali.

[cautions]
1, the material in the market is diverse, please test the performance first and then print it in batch.
2. Other tests, such as alcohol test, adhesion test, abrasion resistance test, etc., need to be done after the ink is completely dry.
3. Ink, the use and storage of diluents strictly prohibit fireworks. When used, pay attention to the ventilation condition of the construction site.
4, try to avoid direct skin contact. For those allergic to this product, a layer of skin creams or wearing gloves should be coated before use.
5, this product is inadvertently splashed in the entrance, nose, eye and ear, and uses a lot of water to clean or direct to the doctor.
[本信息来自于今日推荐网]